After following the steps, you can remove the SD card and put it into the camera’s SD card slot. Then using a computer, do a low-level format of the card, and unzip the downloaded Magic Lantern software and point it to the SD card. Then you should check to make sure the battery is fully charged, removing any additional accessories on the device, set the camera’s mode to Manual (M), upgrade your Canon’s DLSR’s firmware to the latest firmware (500D is 1.1.1, 550D is 1.0.9, 600D is 1.0.1, 50D is 1.0.8, 60D is 1.1.0, and 5D Mark II is 2.1.1), and restore the settings to default settings by selecting Clear all camera settings on the third wrench of the camera’s settings. You will also need a SD card (supposedly a big SDHC card and 64GB cards and larger will not work for first install) and a card reader. You can get it from Magic Lantern’s Download page. It does not replace Canon’s firmware but it runs along side of it.īefore installing magic lantern, make sure your Canon is a 50D, 500D (T1i), 550D (T2i), 60D, or a 600D (t3i) (at the time of the writing, 5DD are in development).
One thing to note that Magic Lantern is a 3rd party firmware that sits on top of Canon’s existing firmware. Some of the abilities include manual audio, zebras, focus assist tools, bracketing, motion detection, on-screen audio meters, and more. When the firmware was first released it was initially programmed for filmmakers with its video functionalists now the firmware is for both video and photo enthusiasts. Magic Lantern is a 3rd party open firmware for Canon DSLR that sits on top of Canon’s firmware that allows users to have many additional features on the device.
0 kommentar(er)
